Pro BRC will clean new brick, concrete and non-glazed tile surfaces without damage when used as directed. This product dissolves construction dirt and mortar smears from exterior building surfaces. Pro BRC will not streak or burn the surface when properly diluted. It works in both hot and cold water. Pro BRC concentrate must be diluted before use. Directions for dilution follow.
Pro BRC Spec Sheet
DO NOT RUN THIS PRODUCT THROUGH PUMPING SYSTEM OR HEATING COILS
Optimum dilution of this product is 1 part chemical to 4 parts water when applied down stream with a pressure washer. Used in a pump sprayer, mix 12 ounces of chemical to each 1 gallon of water. In hard water areas more chemical may be required. Pre-wet surface thoroughly before applying chemical to surface to be cleaned. This will allow for the chemical to work on the surface dirt and not be absorbed into a dry porous surface. Always test chemical in an 'out of the way' area. When cleaning with pressure washers, set the metering valve at desired dilution rate, and apply cleaning solution from the bottom up on a dry surface. Always detail clean from the bottom up and rinse from the top down. Do not use on glass, anodized or polished aluminum. Do not use on delicate paint. Do not allow to dry on surfaces. Always rinse thoroughly.
NOTE: Do not use on and protect the following from fume contact; stainless steel, porcelain, painted enamel surfaces, chrome, brass, of other non-ferrous metals.