Products

  • 0 items in quote

    No products in the Quote Basket.

  • 0 items in quote

    No products in the Quote Basket.

  • Pro 80

    New Masonry Cleaner

    • Buffered acid formulation – low fuming
    • Safe on glass and aluminum frames

    Pro 80 New Masonry Cleaner is a buffered formulation designed to clean masonry structures, and is particularly effective at removing unwanted post-construction mortar residue from brick, tile, block, stone, precast, grout and concrete brick. Pro 80 New Masonry Cleaner can be used on most rough unpolished masonry surfaces. Just spray and rinse. No scrubbing is necessary. This increases square foot production and reduces labor, also reducing brick saturation from which efflorescence can result. There is minimal fuming on this buffered acidic detergent, though there is still a strong odor. It will not harm glass and anodized window frames when used as directed.

    Pro 80 Spec Sheet

    Add to Quote

    Description

    • Buffered acid formulation – low fuming
    • Safe on glass and aluminum frames

    Pro 80 New Masonry Cleaner is a buffered formulation designed to clean masonry structures, and is particularly effective at removing unwanted post-construction mortar residue from brick, tile, block, stone, precast, grout and concrete brick. Pro 80 New Masonry Cleaner can be used on most rough unpolished masonry surfaces. Just spray and rinse. No scrubbing is necessary. This increases square foot production and reduces labor, also reducing brick saturation from which efflorescence can result. There is minimal fuming on this buffered acidic detergent, though there is still a strong odor. It will not harm glass and anodized window frames when used as directed.

    Pro 80 Spec Sheet

    Additional information

    Color

    Clear

    pH

    ≤ 1

    Odor

    Strong

    Physical State

    Liquid

    DOT

    Hazardous

    Dilution

    Concentrate

    Packaging Option

    275 Gallon Tote, 55 Gallon Drum, 5 Gallon Pail, 4×1 Gallon Case

    Do not run this product through pumping system or heating coils. Optimum dilution of this product is 1 part chemical to 4 parts water when applied down stream with a pressure washer. Used in a pump sprayer, mix 12 ounces of chemical to each 1 gallon of water. In hard water areas more chemical may be required. Pre-wet surface thoroughly before applying chemical to surface to be cleaned. This will allow for the chemical to work on the surface dirt and not be absorbed into a dry porous surface. Always test chemical in an 'out of the way' area. When cleaning with pressure washers, set the metering valve at desired dilution rate, and apply cleaning solution from the bottom up on a dry surface. Always detail clean from the bottom up and rinse from the top down. Do not use on glass, anodized or polished aluminum. Do not use on delicate paint. Do not allow to dry on surfaces. Always rinse thoroughly. NOTE: Do not run this product through pumping system or heating coils. Do not use on delicate paint. Do not allow to dry on surfaces. Always rinse thoroughly. Use only on approved masonry surfaces as directed. Use caution with plants, plumbing, wood surfaces and on the elevator door finishes. Cover if necessary. Utilize a low pressure rinse for synthetic stone and surface dyed substrates. Do not brush surface dyed substrates.